InteliLite
NT
AMF26-P, SW version 2.4, ©ComAp – January 2016 73
AMF26-P-2.4 Reference Guide.pdf
IBLite DHCP [ENABLED/DISABLED]
The setpoint is used to select the method how the ethernet connection
is adjusted.
DISABLED:
The ethernet connection is adjusted fixedly according to the setpoints
IP Addr, NetMask, GateIP, DNS IP Address.
This method should be used for classic ethernet or Internet connection. When this type of connection
is opening the controller is specified by it's IP address. That means it would be inconvenient if the IP
address were not fixed (static).
ENABLED:
The ethernet connection settings is obtained automatically from the DHCP
server. The obtained settings is then copied to the related setpoints.
If the process of obtaining the settings from DHCP server is not successful
the value 000.000.000.000 is copied to the setpoint IP address and the
module continues trying to obtain the settings.
ComAp Port [0 - 65535]
This setpoint is used to adjust the port number, which is used for ethernet connection to a PC with any
of ComAp PC program (i.e. InteliLIte, InteliMonitor). This setpoint should be adjusted to 23, which is
the default port used by all ComAp PC programs. A different value should be used only in special
situations as e.g. sharing one public IP address among many controllers or to overcome a firewall
restrictions.
APN Name [-]
Name of APN access point for GPRS network provided by GSM/GPRS operator.
APN User Name [-]
User name for APN access point provided by GSM/GPRS operator.
APN User Pass [-]
User password for APN access point provided by GSM/GPRS operator.
AirGate [Enable/Disable]
Communication mode of internet connection.
Hint:
Valid for IB-Lite only.
AirGate IP [-]
This setpoint is used for entering the domain name or IP address of the AirGate server. Use the free
AirGate server provided by ComAp at address airgate.comap.cz if your company does not operate it's
own AirGate server.
SMTP User Name [-]
Use this setpoint to enter the user name for the SMTP server.
To Next Page
Loading...
