InteliLite
NT
AMF26-P, SW version 2.4, ©ComAp – January 2016 72
AMF26-P-2.4 Reference Guide.pdf
For details on communication speed and other technical parameters please see chapter Technical
Data.
For detail description see chapter Modbus protocol. Since IL-NT version 1.3 controller supports
register oriented modbus.
COM2 Mode [DIRECT/MODBUS/ECU LINK]
Communication protocol switch for the COM2 channel, if dual communication module is pluged in.
DIRECT: LiteEdit communication protocol via direct cable.
MODBUS: Modbus protocol. See detailed description in InteliCommunication guide.
ECU LINK: Protocol for communication with Cummins engines via Modbus.
Hint:
For details on communication speed and other technical parameters please see chapter Technical
Data. For detail description see chapter Modbus protocol. Since IL-NT version 1.3 controller supports
register oriented modbus.
Hint:
Modbus TCP protocol using IB-Lite communication module requires setting COM1 Mode = DIRECT
and COM2 Mode = MODBUS.
ModemIniString
If your modem needs some additional initialization AT commands (i.e. because of national telephony
network differencies), it can be entered here. Otherwise leave this setpoint blank.
ModbusComSpeed [9600,19200, 38400, 57600]
If the Modbus mode is selected on COM1 or COM2 channels, the Modbus communication speed in
bps can be adjusted here.
Hint:
In case of using Modbus TCP, communication speed must be set on 57600, COM2
IBLite IP Addr [-]
If DHCP is DISABLED this setpoint is used to adjust the IP address of the ethernet interface of the
controller. Ask your IT specialist for help with this setting.
If DHCP is ENABLED this setpoint is used to display the IP address, which has been assigned by the
DHCP server.
IBLite NetMask [-]
If DHCP is DISABLED this setpoint is used to adjust the IP address of the ethernet interface of the
controller. Ask your IT specialist for help with this setting.
If DHCP is ENABLED this setpoint is used to display the IP address, which has been assigned by the
DHCP server.
IBLite GateIP [-]
If DHCP is DISABLED this setpoint is used to adjust the IP address of the gateway of the network
segment where the controller is connected.
If DHCP is ENABLED this setpoint is used to display the gateway IP address which has been
assigned by the DHCP server.
A gateway is a device which connects the respective segment with the other segments and/or
Internet.
To Next Page
Loading...
