Cubiscan 325 26
CHAPTER 3
OPERATION
This chapter provides instructions for operating the Cubiscan 325.
NOTE
The Cubiscan 325’s glass platform should be kept clean and free of objects that are
not being measured.
Before you begin
Follow the procedures below to turn on the Cubiscan 325. The Cubiscan
325 should be turned on before you start Qbit (if applicable).
1. Make sure there are no objects on the Cubiscan 325’s platform.
2. Make sure that the gate has enough room to move freely.
3. Turn on the Cubiscan 325. The Cubiscan 325 performs self-diagnostic
procedures that take about 5 seconds. Do not touch the Cubiscan 325
platform during these 5 seconds.
4. The Cubiscan 325 must be zeroed each time it is turned on. For
instructions on zeroing the Cubiscan 325 see “Zeroing the Cubiscan
325” on page 32.
NOTE
Do not lean on or touch the Cubiscan 325 glass platform or the object while the
object is being measured and weighed. Any kind of contact with the platform
during the measurement process can alter the weight or sensor reading.
While the Cubiscan 325 has overload protection, objects heavier than 50 pounds
(25 kg) should not be placed on the platform. Overloading the scale or shock
loading (dropping a heavy object on the scale) can cause permanent zero shift,
making the scale inoperable.
CAUTION
To Next Page
Loading...