Curtiss-Wright R-NET User Manual

Curtiss-Wright | PG Drives Technology
SK77981-14
100 | R-net Technical Manual | Chapter 3 – Programming
11.7 CHARGER INHIBIT 3 LATCHING
This sets whether the On-Board Charger inhibit, which is located in the 3-way charger socket on the Power Module is latching or
non-latching.
Latching means that power must be cycled after the inhibit is removed, in order to resume normal operation.
Non-latching means that normal operation will resume immediately the inhibit is removed.
The programmable options are Yes and No.
If set to Yes, the operation is latching.
If set to No, the operation is non-latching.
NOTE:
Regardless of the setting of this parameter, the Inhibit 3 input can still be used as a multi-state input to provide speed limits
and/or actuator inhibits. See section 13, Inhibits, for more details.
11.8 CHARGER INHIBIT 1 LATCHING
This sets whether the Off-Board Charger inhibit, which is located in the 3-way charger socket on the Joystick Module is latching
or non-latching.
Latching means that power must be cycled after the inhibit is removed, in order to resume normal operation.
Non-latching means that normal operation will resume immediately the inhibit is removed.
The programmable options are Yes and No.
If set to Yes, the operation is latching.
If set to No, the operation is non-latching.
11.9 CHARGER INHIBIT 1 ALARM
This sets whether an alarm sounds if there is a charge inhibit present on Inhibit 1.
A charge inhibit is invoked if an Off-Board Charger is connected into the 3-way charger socket on the Joystick Module.
The programmable options are On and Off.
11.10 CHARGER INHIBIT 3 ALARM
This sets whether an alarm sounds if there is a charge inhibit present on Inhibit 3.
A charge inhibit is invoked if an On-Board Charger is connected to the OBC connector on the Power Module and Charger Inhibit
3 Enable is set to Yes.

Curtiss-Wright R-NET Specifications

General

Brand	Curtiss-Wright
Model	R-NET
Category	Wheelchair
Language	English