Curtiss-Wright R-NET - Maximum Reverse Acceleration - (Rev Accel Max); Minimum Reverse Acceleration - (Rev Accel Min); Maximum Reverse Deceleration - (Rev Decel Max); Minimum Reverse Deceleration

To Next Page

To Previous Page

Curtiss-Wright | PG Drives Technology

SK77981-14

76 | R-net Technical Manual | Chapter 3 – Programming

Sets the deceleration rate of the wheelchair in the forward direction when the speed setting is at minimum (just 1 bar

illuminated).

Programmable range is 0 to Maximum Forward Deceleration in steps of 1%.

NOTE:

It is not possible to set the value of Minimum Forward Deceleration higher than the value of Max. Forward Deceleration.

6.11 MAXIMUM REVERSE ACCELERATION - (REV ACCEL MAX)

Sets the acceleration rate of the wheelchair in the reverse direction when the speed setting is at maximum (all 5 bars

illuminated).

Programmable range is 0 to 100% in steps of 1%.

6.12 MINIMUM REVERSE ACCELERATION - (REV ACCEL MIN)

Sets the acceleration rate of the wheelchair in the reverse direction when the speed setting is at minimum (just 1 bar

illuminated).

Programmable range is 0 to Maximum Reverse Acceleration in steps of 1%.

NOTE:

It is not possible to set the value of Minimum Reverse Acceleration higher than the value of Max. Reverse Acceleration.

6.13 MAXIMUM REVERSE DECELERATION - (REV DECEL MAX)

Sets the deceleration rate of the wheelchair in the reverse direction when the speed setting is at maximum (all 5 bars

illuminated).

Programmable range is 0 to 100% in steps of 1%.

6.14 MINIMUM REVERSE DECELERATION - (REV DECEL MIN)

Sets the deceleration rate of the wheelchair in the reverse direction when the speed setting is at minimum (just 1 bar

illuminated).

Programmable range is 0 to Maximum Reverse Deceleration in steps of 1%.

NOTE:

It is not possible to set the value of Minimum Reverse Deceleration higher than the value of Max. Reverse Deceleration.

6.15 MAXIMUM TURN ACCELERATION - (TURN ACCEL MAX)

Sets the acceleration rate of the wheelchair into a turn when the speed setting is at maximum (all 5 bars illuminated).

Programmable range is 0 to 100% in steps of 1%.

Curtiss-Wright R-NET - Maximum Reverse Acceleration - (Rev Accel Max); Minimum Reverse Acceleration - (Rev Accel Min); Maximum Reverse Deceleration - (Rev Decel Max); Minimum Reverse Deceleration - (Rev Dec el Min)