2.2 OPERATING CONDITIONS
Your control system uses industrial-grade components throughout, ensuring reliable operation in a wide range of conditions.
However, you will improve the reliability of the control system if you keep exposure to extreme conditions to a minimum.
Do not expose your control system or its components to damp for prolonged periods. If the control system becomes
contaminated with food or drink clean it off as soon as possible.
2.3 CLEANING
Clean the control system and the joystick with a cloth dampened with diluted detergent. Be careful when cleaning the joystick
and screen.
Never use abrasive or spirit-based cleaners.
3 MATING CONNECTORS
To connect the Communication Cables:
ï‚· Holding the connector housing, firmly push the connector into its mate until you can no longer see the yellow
plastic.
The connectors are secured using a friction system.
To disconnect the Communication Cables:
ï‚· Holding the connector housing firmly, pull the connectors apart.
NOTE:
Do not hold or pull on the cable. Always grip the connector when connecting and disconnecting.
When the control system is first switched on after a connection, or system component change the Timer will be displayed
whilst the system checks itself and then the Re-start icon will be displayed. Switch the control system off and on again to
operate.
To Next Page
Loading...
Need help?
General
