CHAPTER 4 – ELPM 90, JSM-LED & SM
1 INTRODUCTION
This section describes the differences between the previous sections if any of the following modules are used. It is therefore
important that all the previous sections have been read and understood.
JSM-LED LED Joystick Module
JSM-LED-L LED Joystick Module with lighting control buttons
EL PM90 EL 90A Power Module
SM Seating Module
NOTE:
The EL PM90 can actually be used with any R-net JSM, including LCD based versions, as well as an Omni or any other Input
Device.
The LED JSMs can actually be used with any R-net PM, ISM or any other Output Device.
The SM can only be used with the EL PM90.
The JSM-Led should not be used for Latched drive operation, there is no facility to fit an E-stop switch to the LED Joystick
Module.
To Next Page
Loading...
Need help?
General
