Curtiss-Wright R-NET - Buttons

Curtiss-Wright | PG Drives Technology
SK77981-14
14 | R-net Technical Manual | Chapter 1 - Operation
4.2 BUTTONS
4.2.1 ON/OFF BUTTON
The On/Off button applies power to the control system electronics, which in turn supply power to the wheelchair’s motors. Do
not use the On/Off button to stop the wheelchair unless there is an emergency. (If you do, you may shorten the life of the
wheelchair drive components).
4.2.2 HORN BUTTON
The Horn will sound while this button is depressed.
4.2.3 SPEED DECREASE BUTTON
This button decreases the maximum speed setting.
Depending on the way the control system has been programmed a momentary screen may be displayed when the button is
pressed.
Refer to section 5 for details of the momentary screen.
Refer to Chapter 3 - Programming for details.
4.2.4 SPEED INCREASE BUTTON
This button increases the maximum speed setting.
Depending on the way the control system has been programmed a momentary screen may be displayed when the button is
pressed.
Refer to section 5 for details of the momentary screen.
Refer to Chapter 3 - Programming for details.