7 GETTING READY TO DRIVE
Operate the On/Off switch. The screen will go through an initializing process then show the base screen as follows. In
the case on an LED Joystick Module the battery gauge will illuminate.
Check that the Speed Setting is at a level that suits you.
Push the joystick to control the speed and direction of the wheelchair.
NOTE:
If you push the joystick before or just after you switch the control system on, the screen will flash the joystick displaced
screen. You must release and center the joystick to resume normal operation. If you do not release the joystick within five
seconds the wheelchair will not be able to move, even if you release the joystick and push it again. The screen will display the
diagnostic screen at this time. You can reset this condition by switching the control system off and on again.
If you do not push the joystick as you switch the wheelchair on and the diagnostic screen is displayed, as in the following
diagram, then the R-net has detected a problem somewhere in the wheelchair’s electrical system.
To Next Page
Loading...
Need help?
General
