Curtiss-Wright R-NET User Manual

Curtiss-Wright | PG Drives Technology
SK77981-14
21 | R-net Technical Manual | Chapter 1 - Operation
5.4 LOCKING THE CONTROL SYSTEM
The Control System can be locked in one of two ways. Either using a button sequence on the keypad or with a physical Key. How
the Control System is locked depends on how the wheelchair manufacturer has programmed the system.
5.4.1 KEYPAD LOCKING
To lock the wheelchair using the keypad;
 While the control system is switched on, depress and hold the On/Off button.
 After 1 second the control system will beep. Now release the On/Off button
 Deflect the joystick forwards until the control sys tem beeps.
 Deflect the joystick in reverse until the control system beeps.
 Release the joystick, there will be a long beep.
 The wheelchair is now locked.
The following screen will be displayed, the next time the Control System is switched on.
If an LED Joystick Module is fitted the Speed Indicator LEDs will ripple from left to right. Refer to Chapter 4.
To unlock the wheelchair:
 If the control system has switched off, press the On/Off button.
 Deflect the joystick forwards until the control system beeps.
 Deflect the joystick in reverse until the control system beeps.
 Release the joystick, there will be a long beep.
 The wheelchair is now unlocked.
5.4.2 KEY LOCKING
To lock the wheelchair with a key;
 With the Control System switched on, insert and remove a Curtiss-Wright supplied key into the Charger Socket on the
Joystick Module. A short beep will be heard.
 The wheelchair is now locked.
The following screen will be displayed, the next time the Control System is switched on.

Curtiss-Wright R-NET Specifications

General

Brand	Curtiss-Wright
Model	R-NET
Category	Wheelchair
Language	English