4.2.12 EXTERNAL PROFILE SWITCH JACK
This allows the user to select Profiles using an external device, such as a buddy button.
To change the Profile whilst driving simply press the button.
If the control system is set to latched drive or actuator control operation, then the polarity of the jack input is reversed to effect
a fail-safe system; meaning this input will provide an External Profile Switch function and an Emergency Stop Switch function.
NOTE:
The Joystick Module is supplied with rubber bungs that must be inserted into the Jack Socket when no external device is
connected.
4.3 LCD SCREEN
The status of the control system can be understood by observing the LCD screen. The control system is on when the screen is
backlit.
Refer to section 5 for details on screen symbols.
4.4 CHARGER SOCKET
This socket should only be used for charging or locking the wheelchair. Do not connect any type of programming cable into this
socket.
Refer to section 13 for more details on charging.
This socket should not be used as a power supply for any other electrical device. Connection of other electrical devices may
damage the control system or affect the E.M.C. performance of the wheelchair.
WARNING:
The control system’s warranty will be voided if any device other than a battery charger supplied, with the wheelchair, or the
lock key is connected into this socket.
To Next Page
Loading...
Need help?
General
