Curtiss-Wright R-NET - Maximum Turning Speed - (Turn Speed Max); Minimum Turning Speed - (Turn Speed Min); Maximum Forward Acceleration - (Fwd Accel Max)75; Minimum Forward Acceleration - (Fwd Accel Min)

Curtiss-Wright | PG Drives Technology
SK77981-14
75 | R-net Technical Manual | Chapter 3 – Programming
6.5 MAXIMUM TURNING SPEED - (TURN SPEED MAX)
Sets the turning speed of the wheelchair when the joystick is deflected fully left or right and the speed setting is at maximum
(all 5 bars illuminated).
Programmable range is 0 to 100% in steps of 1%.
6.6 MINIMUM TURNING SPEED - (TURN SPEED MIN)
Sets the turning speed of the wheelchair when the joystick is deflected full left or right and the speed setting is at minimum (just
1 bar illuminated).
Programmable range is 0 to Maximum Turning Speed in steps of 1%.
NOTE:
It is not possible to set the value of Minimum Turning Speed higher than the value of Max. Turning Speed.
6.7 MAXIMUM FORWARD ACCELERATION - (FWD ACCEL MAX)
Sets the acceleration rate of the wheelchair in the forward direction when the speed setting is at maximum (all 5 bars
illuminated).
Programmable range is 0 to 100% in steps of 1%.
6.8 MINIMUM FORWARD ACCELERATION - (FWD ACCEL MIN)
Sets the acceleration rate of the wheelchair in the forward direction when the speed setting is at minimum (just 1 bar
illuminated).
Programmable range is 0 to Maximum Forward Acceleration in steps of 1%.
NOTE:
It is not possible to set the value of Minimum Forward Acceleration higher than the value of Max. Forward Acceleration.
6.9 MAXIMUM FORWARD DECELERATION - (FWD DECEL MAX)
Sets the deceleration rate of the wheelchair in the forward direction when the speed setting is at maximum (all 5 bars
illuminated).
Programmable range is 0 to 100% in steps of 1%.
6.10 MINIMUM FORWARD DECELERATION - (FWD DECEL MIN)