The chair manufacturer is responsible for ensuring that only the mating connectors specified by Curtiss-Wright on the control
system’s specific data sheet are used to connect to the control system. Curtiss-Wright accepts no liability for losses of any
kind arising from failure to comply with this condition.
The chair manufacturer is responsible for ensuring that suitable connectors are used and securely mated throughout the
chair wiring system and that the workmanship associated with the wiring system is of a good enough quality. Failure to meet
this condition could result in intermittent operation, sudden stopping or veering, or even create a burn or fire hazard. Curtiss-
Wright accepts no liability for losses of any kind arising from failure to comply with this condition.
The power connectors for the R-net Power Module are specially designed by Curtiss-Wright for wheelchair applications. The
crimps are standard AMP Timer parts but the plastic housings are custom. These connectors can be purchased from Curtiss-
Wright or from Greenstock directly. Greenstock will also provide a pre-assembled cable service. Contact details for Greenstock
are as follows: Greenstock Tel: +44 (0) 0845 2570444 www.greenstock.co.uk
The connector part numbers are as shown in the following table:
To Next Page
Loading...
Need help?
General
