D-Link DSR-Series User Manual 43
Section 5 - Connect to the Internet
WAN3 (3G Internet)
Path: Network > Internet > WAN3 Settings
This router supports the use of 3G Internet access. Cellular 3G internet access is available on WAN3 via a 3G USB
modem for DSR series. The cellular ISP that provides the 3G data plan will provide the authentication requirements
to establish a connection. The dial Number and APN are speciīc to the cellular carriers. Once the connection type
settings are conīgured and saved, navigate to the WAN status page (Setup > Internet Settings > WAN3 Status)
and Enable the WAN3 link to establish the 3G connection.
Field Description
Reconnect Mode
Some ISPs may require you to pay for usage time. Select On Demand if this is the case. This will have the
router connect to the Internet only when you initiate an Internet connection. Select Always On to have
the router stay connected to the Internet.
Maximum Idle Time Enter the idle time in minutes before the router disconnects from the Internet (On Demand only).
User Name Enter your 3G account user name.
Password Enter your 3G account password.
Dial-in Number Enter the phone number to access your Internet.
Authentication Proto-
col
Select one of following protocols from the drop-down menu: None, PAP or CHAP.
APN Required Toggle to ON if your ISP requires APN to connect.
APN Enter the APN (Access Point Name) provided by the ISP.
DNS Server Source Select either Get Dynamically from ISP or Use These DNS Servers to manually enter DNS servers.
Primary DNS Server If you selected āUse These DNS Serversā, enter the primary DNS server IP address.
Secondary DNS Server If you selected āUse These DNS Serversā, enter the secondary DNS server IP address.
MTU Size Select to use the default MTU value (1500) or select Custom to enter your own value.
Custom MTU Enter a MTU value to optimize performance with your ISP.
Note: WAN3 (3G Internet) is available only in DSR-1000AC.
To Next Page
Loading...
Need help?
General
