D-Link DSR-1000 User Manual

D-Link DSR-Series User Manual 52
Section 5 - Connect to the Internet
Bridge
Field Description
Routing Settings Select Bridge.
Bridge Interface IP
Address
Enter the bridge interface IP address.
DMZ Interface IP
Address
Enter the DMZ interface IP address.
Subnet Mask Enter the subnet mask.
NAT with WAN1 Toggle ON to turn NAT on WAN1 or OFF for classical.
Save Click to save and activate your settings.
When Bridge Mode routing is enabled, the rst physical LAN port and secondary WAN/DMZ (port 2) interfaces
are bridged together at Layer 2, creating an aggregate network. The other LAN ports and the primary WAN
(WAN1) are not part of this bridge, and the router asks as a NAT device for these other ports. With Bridge mode
for the LAN port 1 and WAN2/DMZ interfaces, L2 and L3 broadcast trac as well as ARP / RARP packets are
passed through. When WAN2 receives tagged trac the tag information will be removed before the packet is
forwarded to the LAN port 1 interface.
Note: Bridge mode option is available on DSR-500 / 500AC /1000 / 1000AC routers only.
1. Click Network > Internet > Routing.
2. Complete the elds from the table below and click Save.

D-Link DSR-1000 Specifications

General

Brand	D-Link
Model	DSR-1000
Category	Network Router
Language	English