D-Link DSR-1000 User Manual

D-Link DSR-Series User Manual 246
Section 9 - Maintenance
Syslog
Path: Maintenance > Logs Settings > Remote Logging > Syslog
An external Syslog server is often used to collect and store logs from the router. This remote device typically has
less memory constraints than the local Event Viewer on the router. Therefore, a number of logs can be collected
over a sustained period. This is useful for debugging network issues or to monitor router trac over a long
duration.
The router supports eight concurrent Syslog servers. Each server can be congured to receive dierent log
facility messages of varying severity using the Remote Logs page. This page also lets you send conguration
logs to three email recipients.
1. Click Maintenance > Log Settings > Remote Logging and click Syslog tab.
2. Complete the elds from the table on the next page and click Save.
Field Description
Syslog Server 1 Toggle to ON to setup a Syslog server.
FQDN / IP Address Enter the IP address or Internet Name of the Syslog server.
Facility Select which facility you want to log. Refer to “Dening What to Log” on page 239 for denitions.
Severity
Select the severity level you want to log. Refer to “Dening What to Log” on page 239 for
denitions.
Syslog Server 2 to N
Toggle to ON to setup another Syslog server. Repeat the elds above for each server you want to
setup. The value of N for the DSR models are given below:
DSR-1000/1000AC: 10
DSR-500/500AC: 7
DSR-250/250N: 5
DSR-150/150N: 2
Save Click save and activate your settings.

D-Link DSR-1000 Specifications

General

Brand	D-Link
Model	DSR-1000
Category	Network Router
Language	English