D-Link DSR-1000 User Manual

D-Link DSR-Series User Manual 54
Section 5 - Connect to the Internet
Field Description
IP Address Enter an IP address for the DMZ interface.
Subnet Mask Enter the subnet mask for the DMZ interface.
DHCP Mode
Select one of the following modes:
• None - Turns o DHCP.
• DHCP Server (default) - The router will act as the DHCP server on your network.
• DHCP Relay - DHCP clients on your network will receive IP address leases from a DHCP server on a
dierent subnet.
DHCP Server Refer to “DHCP Server” on page 19 for more information.
DHCP Relay Refer to “DHCP Relay” on page 20 for more information.
Enable DNS Proxy
Toggle to On to manually enter DNS and/or WINS server IP address(es). If set to O, your router’s LAN
IP address will be assigned the DNS server to your clients and the router will get the DNS information
from your ISP.
Primary DNS Server If DNS Proxy is set to ON, enter the primary DNS server IP address.
Secondary DNS Server If DNS Proxy is set to ON, enter the secondary DNS server IP address.
WINS Server If DNS Proxy is set to ON, enter the WINS server IP address.
Save Click to save and activate your settings.
DMZ Settings
Path: Network > Internet > DMZ Settings
If you set WAN2 port to DMZ, you will need to congure the port here.
To congure the DMZ Settings:
1. Click Network > Internet > DMZ Settings.
2. Complete the elds from the table below and click Save.

D-Link DSR-1000 Specifications

General

Brand	D-Link
Model	DSR-1000
Category	Network Router
Language	English