xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide
7
This window holds the following information:
Parameter Description
ID
State the ID number of the configuration file located in the Switch’s memory. The
Switch can store two configuration files for use. ID 1 will be the default boot up
configuration file for the Switch unless otherwise configured by the user.
Version
Display the firmware version that has been saved or uploaded in the Switch.
Size (Bytes)
Display the size of the configuration file, in bytes.
Update Time
Display the time that the configuration file was updated to the Switch.
From
Display the location from which the configuration file was uploaded.
User
Display the name of the user (device) that updated this configuration file. Unknown
users will be displayed as Anonymous.
Click the corresponding Set Boot button to use the configuration file as the boot up firmware for the Switch. This
will apply upon the next reboot of the Switch.
Click the Active button to enable the configuration file settings.
Click the corresponding Delete button to remove this configuration file from the Switch’s memory.
Firmware Information Settings
The following screen allows the user to view information about current firmware images stored on the Switch.
To access this table, click System Configuration > Firmware Information Settings
Figure 2 - 2 Firmware Information window
This window holds the following information:
Parameter Description
ID
States the image ID number of the firmware in the Switch’s memory. The Switch can
store two firmware images for use. Image ID 1 will be the default boot up firmware for
the Switch unless otherwise configured by the user.
Version
States the firmware version.
Size (Bytes)
States the size of the corresponding firmware, in bytes.
Update Time
States the specific time the firmware version was downloaded to the Switch.
To Next Page
Loading...
