NOTE: When enabling redirect to the quarantine server, a quarantine
server must be configured first.
Redirect Destination
This parameter specifies the destination before an unauthenticated host is redirected to
either the Quarantine Server or the JWAC Login Page.
Redirect Delay Time
(0-10)
This parameter specifies the Delay Time before an unauthenticated host is redirected to
the Quarantine Server or JWAC Login Page. Enter a value between 0 and 10 seconds.
A value of 0 indicates no delay in the redirect.
RADIUS Authorization Specifies to Enable or Disable RADIUS Authorization.
Local Authorization Specifies to Enable or Disable Local Authorization.
Error Timeout
(5-300)
This parameter is used to set the Quarantine Server Error Timeout. When the
Quarantine Server Monitor is enabled, the JWAC Switch will periodically check if the
Quarantine works okay. If the Switch does not receive any response from the
Quarantine Server during the configured Error Timeout, the Switch then regards it as
not working properly. Enter a value between 5 and 300 seconds.
Monitor
This parameter enables or disables the JWAC Quarantine Server Monitor. When
Enabled, the JWAC Switch will monitor the Quarantine Server to ensure the server is
okay. If the Switch detects no Quarantine Server, it will redirect all unauthenticated
HTTP access attempts to the JWAC Login Page forcibly if the Redirect is enabled and
the Redirect Destination is configured to be a Quarantine Server.
URL
This parameter specifies the JWAC Quarantine Server URL. If the Redirect is enabled
and the Redirect Destination is the Quarantine Server, when an unauthenticated host
sends the HTTP request packets to a random Web server, the Switch will handle this
HTTP packet and send back a message to the host to allow it access to the Quarantine
Server with the configured URL. When a computer is connected to the specified URL,
the quarantine server will request the computer user to input the user name and
password to complete the authentication process.
Update Server IP
This parameter specifies the Update Server IP address.
Mask (e.g.:
255.255.255.254 or 8-
32)
This parameter specifies the Server IP net mask.
Port (1-65535)
The accessible TCP or UDP port for the specified update server network.
Click the Apply button to accept the changes made for each individual section.
Click the Add button to add the Update Sever Settings information.
JWAC Port Settings
To view this window, click Security > JWAC > JWAC Port Settings, as shown below:
To Next Page
Loading...
Need help?
General