D-Link xStack DES-3528 Series - DDM Temperature Threshold Settings

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide
9
Figure 2-3 DDM Settings window
The fields that can be configured are described below:
Parameter Description
Trap State
Specify whether to send the trap, when the operating parameter exceeds the alarm or
warning threshold.
Log State
Specify whether to send the log, when the operating parameter exceeds the alarm or
warning threshold.
Power Unit
Specify the unit of the DDM TX and RX power.
Unit
Select the unit to configure.
From Port / To Port
Select a range of ports to be configured.
State
Use the drop-down menu to enable or disable the DDM state.
Shutdown Specify whether to shutdown the port, when the operating parameter exceeds the Alarm or
Warning threshold.
Alarm - Shutdown the port when the configured alarm threshold range is exceeded.
Warning - Shutdown the port when the configured warning threshold range is exceeded.
None - The port will never shutdown regardless if the threshold ranges are exceeded or
not. This is the default.
Click the Apply button to accept the changes made for each individual section.
DDM Temperature Threshold Settings
This window is used to configure the DDM Temperature Threshold Settings for specific ports on the Switch.