D-Link xStack DES-3528 Series - Authenticator Diagnostics; Initialize Port(S)

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide
223
Authenticator Diagnostics
This table contains the diagnostic information regarding the operation of the Authenticator associated with each
port. An entry appears in this table for each port that supports the Authenticator function.
To view this window, click Security > 802.1X > Authenticator Diagnostics, as shown below:
Figure 8-17 Authenticator Diagnostics window
The fields that can be configured are described below:
Parameter Description
Unit
Select the unit to be displayed.
Port
Select the port to be displayed.
Click the Apply button to accept the changes made.
NOTE: The Authenticator Diagnostics cannot be viewed on the Switch unless 802.1X is enabled.
To enable 802.1X, go to Security > 802.1X > 802.1X Global Settings, and select Enabled
from the Authentication State drop-down menu.
Initialize Port(s)
Existing 802.1X port and MAC settings are displayed and can be configured using the window below.