xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide
245
To view this window, click Security > Web-based Access Control (WAC) > WAC Authentication State, as
shown below:
Figure 8-40 WAC Authentication State window
The fields that can be configured are described below:
Parameter Description
Port List (e.g.: 1:1,
1:5-1:10)
Use the drop-down menus to select the desired range of ports and tick the appropriate
check box(s), Authenticated, Authenticating, and Blocked.
Authenticated
Tick this check box to clear all authenticated users for a port.
Authenticating
Tick this check box to clear all authenticating users for a port.
Blocked
Tick this check box to clear all blocked users for a port.
Click the Find button to locate a specific entry based on the information entered.
Click the Clear by Port button to remove entry based on the port list entered.
Click the View All Hosts button to display all the existing entries.
Click the Clear All Hosts button to remove all the entries listed.
Japanese Web-based Access Control (JWAC)
The JWAC folder contains three windows: JWAC Global Settings, JWAC Port Settings, and JWAC User Settings.
JWAC Global Settings
Use this window to enable and configure Japanese Web-based Access Control on the Switch. Please note that
JWAC and Web Authentication are mutually exclusive functions. That is, they cannot be enabled at the same time.
To use the JWAC feature, computer users need to pass through two stages of authentication. The first stage is to
do the authentication with the quarantine server and the second stage is the authentication with the Switch. For the
second stage, the authentication is similar to Web Authentication. The RADIUS server will share the server
configuration defined by the 802.1X command set.
To view this window, click Security > JWAC > JWAC Global Settings, as shown below:
To Next Page
Loading...
