xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide
340
Repeat Pinging for
Enter the number of times desired to attempt to Ping either the IPv4 address or the IPv6
address configured in this window. Users may enter a number of times between 1 and
255.
Size For IPv6 only, enter a value between 1 and 6000. The default is 100.
Timeout Select a timeout period between 1 and 99 seconds for this Ping message to reach its
destination. If the packet fails to find the IP address in this specified time, the Ping
packet will be dropped.
Click the Start button to initiate the Ping Test.
After clicking the Start button, the following page will appear:
Figure 11-24 Ping Test Result window
Click the Stop button to halt the Ping Test.
Click the Resume button to resume the Ping Test.
Trace Route
The trace route page allows the user to trace a route between the Switch and a given host on the network.
To view this window, click Monitoring > Trace Route, as shown below:
Figure 11-25 Trace Route window
To Next Page
Loading...
Need help?
General