xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide
248
Figure 8-42 JWAC Port Settings window
The fields that can be configured are described below:
Parameter Description
Unit
Select the unit to configure.
From Port / To Port
Use the drop-down menus to select a port or range of ports to configure.
State
Specify the state of the configured ports.
Max Authenticating
Host (0-50)
Specify the maximum number of host process authentication attempts allowed on each
port at the same time.
Aging Time (1-1440)
Specify the period of time that a host will keep in authenticated state after it successes
to authenticate. Enter a value between 1 and 1440 minutes. The default setting is 1440
minutes. To maintain a constant Port Configuration, tick the Infinite check box.
Block Time (0-300)
Specify the period of time that a host will keep in a blocked state after it fails to
authenticate. Enter a value between 0 and 300 seconds. The default setting is 60
seconds.
Idle Time (1-1440)
Specify the period of time during which there is no traffic for an authenticated host and
the host will be moved back to the unauthenticated state. Enter a value between 1 and
1440 minutes. Tick the Infinite check box so that the Idle state of the authenticated host
on the port will never be checked. The default setting is Infinite.
Click Apply to implement changes made.
JWAC User Settings
To view this window, click Security > JWAC > JWAC User Settings, as shown below:
To Next Page
Loading...
