xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide
307
CFM Port Settings
This table is used to enable or disable the connectivity fault management function on a per port basis. CFM is
disabled on all ports by default.
To view this window, click OAM > CFM > CFM Port Settings, as shown below:
Figure 10-8 CFM Port Settings window
The fields that can be configured are described below:
Parameter Description
Unit
Select the unit to configure.
From Port / To Port
Use the drop-down menus to select a port or range of ports to configure.
State
Use the drop-down menu to enable or disable the function.
Click the Apply button to implement the changes made.
CFM Loopback Settings
This window is used to configure the CFM Loopback settings on the Switch.
To view this window, click OAM > CFM > CFM Loopback Settings, as shown below:
To Next Page
Loading...
Need help?
General