D-Link xStack DES-3528 Series - Page 156

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide
149
To view the following window, click L2 Features > LLDP > LLDP-MED > LLDP-MED Port Settings, as shown
below:
Figure 4–97 LLDP-MED Port Settings Window
The fields that can be configured are described below:
Parameter Description
Unit
Select a unit to configure.
From Port / To Port
Specifies a range of ports to be configured.
NTCS
Here the user can enable or disable the notification topology change status.
State
Here the user can enable or disable TLVs.
Capabilities
This TLV type indicates that LLDP agent should transmit 'LLDP-MED capabilities TLV'.
If user wants to transmit LLDP-MED PDU, this TLV type should be enabled. Otherwise,
this port cannot transmit LLDP-MED PDU.
Network Policy
This TLV type indicates that LLDP agent should transmit 'LLDP-MED network policy
TLV'.
Power Pse
This TLV type indicates that the LLDP agent should transmit “LLDP-MED power PSE
TLV".
Inventory
This TLV type indicates that LLDP agent should transmit 'LLDP-MED inventory TLV'.
All Select this option to include Capabilities, Network Policy, Power Pse, and Inventory
in the configuration.
Click the Apply button to accept the changes made.
LLDP-MED Local Port Information
On this page the LLDP-MED local port information will be displayed per port.
To view the following window, click L2 Features > LLDP > LLDP-MED > LLDP-MED Local Port Information, as
shown below: