D-Link xStack DES-3528 Series - Page 218

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide
211
Figure 7-46 ACL Flow meter Configuration window
The fields that can be configured are described below:
Parameter Description
Profile ID (1-14)
Enter the Profile ID for the flow meter.
Profile Name
Enter the Profile Name for the flow meter.
Access ID (1-
128)
Enter the Access ID for the flow meter.
Mode
Rate – Specify the rate for single rate two color mode.
• Rate – Specify the committed bandwidth in Kbps for the flow.
• Burst Size – Specify the burst size for the single rate two color mode. The unit is in
kilobyte.
• Rate Exceeded – Specify the action for packets that exceed the committed rate in
single rate two color mode. The action can be specified as one of the following:
o Drop Packet – Drop the overload packets immediately.
o Remark DSCP – Mark the packet with a specified DSCP.
trTCM – Specify the “two-rate three-color mode.”
• CIR – Specify the Committed information Rate. The unit is Kbps. CIR should always
be equal or less than PIR.
• PIR – Specify the Peak information Rate. The unit is Kbps. PIR should always be
equal to or greater than CIR.
• CBS – Specify the Committed Burst Size. The unit is in kilobyte.
• PBS – Specify the Peak Burst Size. The unit is in kilobyte.
srTCM – Specify the “single-rate three-color mode”.
• CIR – Specify the Committed Information Rate. The unit is in kilobyte.
• CBS – Specify the Committed Burst Size. The unit is in kilobyte.