D-Link xStack DES-3528 Series Reference Guide

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide
335
To view this window, click Monitoring > Mirror > RSPAN Settings, as shown below:
Figure 11-17 RSPAN Settings window
The fields that can be configured are described below:
Parameter Description
RSPAN State
Click the radio buttons to enable or disable the RSPAN feature.
VLAN Name
Create the RSPAN VLAN by VLAN name.
VID
Create the RSPAN VLAN by VLAN ID.
Click the Apply button to accept the changes made.
Click the Add button to add a new entry based on the information entered.
Click the Modify button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
After clicking the Modify button, the following page will appear:
Figure 11-18 RSPAN Settings – Modify window
The fields that can be configured are described below:
Parameter Description
VID
Displays the RSPAN VLAN by VLAN ID.
VLAN Name
Displays the RSPAN VLAN by VLAN name.
Source Ports
If the ports are not specified by option, the source of RSPAN will come from the source
specified by the mirror command or the flow-based source specified by an ACL. If no
parameter is specified for Source, it deletes the configured source parameters.
Select RX, TX or Both to specify in which direction the packets will be monitored. Tick
Add or Delete to add or delete source ports.
Redirect Port List
Specify the output port list for the RSPAN VLAN packets. If the redirect port is a Link
Aggregation port, the Link Aggregation behavior will apply to the RSPAN packets. Tick

D-Link xStack DES-3528 Series Specifications

General

Brand	D-Link
Model	xStack DES-3528 Series
Category	Switch
Language	English