Figure 4-132
4.15 Alarm Events
4.15.1 Video Detect
4.15.1.1 Motion Detect
In the main menu, from Setting->Video detect->Motion detect, you can see motion detect interface.
See Figure 4-133. There are five detection types: motion detection, video loss, tampering, scene
change, diagnosis.
The video loss has no detection region and sensitivity setup and tampering has no detection
region setup.
You can see motion detect icon if current channel has enabled motion detect alarm.
You can drag you mouse to set motion detect region. Please click OK button to save current
region setup. Right click mouse to exit current interface.
For digital channel, the detect function refers to support detection function of the front-end and
support local activation function. The front-end can get enable/disable status, sensitivity and
region setup. You can get corresponding prompt if front-end can not get the above information.
You can change front-end setup if it can get.
4.15.1.1.1 Motion Detect
After analysis video, system can generate a video loss alarm when the detected moving signal reached
the sensitivity you set here.
Detection menu is shown as below. See Figure 4-133.
To Next Page
Loading...
