4 Overview of Navigation and Controls
4.1 Initial Settings
4.1.1 Boot up
Before the boot up, please make sure:
The rated input voltage matches the device power on-off button. Please make sure the power wire
connection is OK. Then click the power on-off button.
Always use the stable current, if necessary UPS is a best alternative measure.
Please follow the steps listed below to boot up the device.
Connect the device to the monitor and then connect a mouse.
Connect power cable.
Click the power button at the front or rear panel and then boot up the device. After device booted up,
the system is in multiple-channel display mode by default.
4.1.2 Set Password
For your own safety, please set your administrator password after your first login.
After system booted up, you can see the following interface if it is your first login or you have restored
default setup. See Figure 4-1. Please input a password and then input again to set a new password.
You can set security questions here to reset the password in case you forgot. System supports
customized setup. Please note you need to set two security questions at the same time. When you
reset the password, you need to answer these two security questions too.
For reset information, please refer to chapter 4.1.3.
Figure 4-1
Click OK button, system pops up the following interface. See Figure 4-2.
Click OK button to exit.
To Next Page
Loading...
Need help?
General