It is to adjust monitor window saturation. The default value is 7.
The larger the number, the strong the color is. This value has no effect on
the general brightness of the whole video. The video color may become
too strong if the value is too high. For the grey part of the video, the
distortion may occur if the white balance is not accurate. Please note the
video may not be attractive if the value is too low. The recommended value
ranges from 0 to 15.
The value here is to adjust the edge of the video. The value ranges from 0
to 100. The larger the value is, the clear the edge is and vice versa. Please
note there is noise if the value here is too high.
It is to set flip or pan operation.
It is to set the image mode: color/black and white/auto. It has no
relationship with the configuration file setup. The default setup is auto.
Color: Camera outputs color image.
Auto: System auto select image mode(color/black and white)
according to the camera features(the whole brightness or there is IR
light or not.)
Black and white: Camera outputs black and white image.
In the fog or haze environment, you can enable defog function to enhance
video effect.
Close: It is to close defog mode.
Manual: Select different defog intensity manually.
Auto: It is to auto adjust video to guarantee clear image.
Click it to get latest setup.
Click it to restore factory default setup.
Click Save to complete the setup.
4.3.7 Auto Focus
Note
This function is for the motorized-lens network camera.
For HDMI HD auto focus camera, you can go to the PTZ control interface to set, Please refer to
Chapter 4.7.
On the preview interface, right click mouse and then select Auto focus, you can go to the following
interface. See Figure 4-38.
It is to set auto focus and zoom function. Click auto focus function, camera can realize auto focus
function.
To Next Page
Loading...
