Select the import file and then click the OK button. System pops up a dialogue box to remind you
successfully exported. Please click OK button to exit.
Note:
If the imported IP has conflicted with current added device, system pops up a dialogue box to remind you.
You have two options:
OK: Click OK button, system uses the imported setup to overlay current one.
Cancel: Click Cancel button, system adds the new IP setup.
Important
You can edit the exported .CVS file. Do not change the file format; otherwise it may result in
import failure.
Does not support customized protocol import and export.
The import and export device shall have the same language format.
4.2.5 Encode
Tips
From main menu->Setting->Camera->Encode, you can also go to the following interface.
4.2.5.1 Encode
Click Next button, you can go to Encode interface. See Figure 4-20.
Channel: Select the channel you want.
SVC: SVC is so called scaled video coding. Check the box to enable this function. During the
network transmission process, system discards unimportant frames when the bandwidth is not
sufficient or the decode capability is low. It is to guarantee video quality and transmission fluency.
Type: Please select from the dropdown list. There are three options: regular/motion detect/alarm.
You can set the various encode parameters for different record types.
Compression: System supports H.264H, H.264, H.264B, and MJPEG.
H.264H: It is the High Profile compression algorithm. It has the high encode compression rate. It
can achieve high quality encode at low bit stream. Usually we recommend this type.
H.264 is the general compression algorithm.
H.264B is the Baseline algorithm. Its compression rate is low. For the same video quality, it has
high bit stream requirements.
Smart codec: Select Start from the dropdown list to enable smart codec function. The DVR can auto
reduce the video bit stream of the non-important surveillance object to save the storage space.
Resolution: It is to set video resolution. The higher the resolution is, the better the video quality is.
Frame rate: It ranges from 1f/s to 25f/s in NTSC mode and 1f/s to 30f/s in PAL mode.
Bit rate type: System supports two types: CBR and VBR. In VBR mode, you can set video quality.
Quality: There are six levels ranging from 1 to 6. The sixth level has the highest image quality.
Video/audio: You can enable or disable the video/audio.
Audio format: Please select from the dropdown list. There are three options: G711a/G711u/PCM.
Audio source: Please select from the dropdown list. There are two options: local/HDCVI. For local
mode, the audio signal is from the Audio In port. For HDCVI mode, the audio signal is from the
coaxial cable of the camera.
To Next Page
Loading...
Need help?
General