Figure 4-137
Motion detect here only has relationship with the sensitivity and region setup. It has no relationship
with other setups.
4.15.1.1.2 Video Loss
In Figure 4-133, select video loss from the type list. You can see the interface is shown as in Figure
4-138.This function allows you to be informed when video loss phenomenon occurred. You can
enable alarm output channel and then enable show message function.
Tips:
You can enable preset/tour/pattern activation operation when video loss occurs.
Please refer to chapter 4.15.1.1.1 motion detection for detailed information.
To Next Page
Loading...
