Record channel: you can select proper channel to record alarm video (Multiple choices). At the
same time you need to set alarm record in schedule interface (Main Menu->Setting->Schedule) and
select schedule record in manual record interface (Main Menu->Advance->Manual Record).
Latch: Here is for you to set proper delay duration. Value ranges from 10 to 300 seconds. System
automatically delays specified seconds in turning off alarm and activated output after external alarm
cancelled.
Tour: Here you can enable tour function when alarm occurs. System supports 1/8-window tour.
Please note the tour setup here has higher priority than the tour setup you set in the Display
interface. Once there two tours are both enabled, system can enable the alarm tour as you set here
when an alarm occurred. If there is no alarm, system implements the tour setup in the Display
interface.
Snapshot: System can snapshot corresponding channel when an alarm occurs. Please note the
activation snapshot has the higher priority than schedule snapshot. If you have enabled these two
types at the same time, system can activate the activation snapshot when alarm occurs, and
otherwise system just operates the schedule snapshot.
Video matrix: Check the box here to enable this function. When an alarm occurs, VIDEO OUTPUT
port displays device video output. It displays video (1-window tour) from alarm activation channel
you select at the Record channel interface. It has high priority than the tour setup in Main
menu->Setting->System->Video matrix. Please note this function is for some series product only.
Log: Check the box here, system can record local alarm log.
Buzzer: Highlight the icon to enable this function. The buzzer beeps when alarm occurs.
Voice prompts: Check the box here to trigger audio broadcast function. You can select specified
audio file here. System can play the audio file once the corresponding event occurs.
Please note, network alarm means the alarm signal from the TCP/IP. You can use NET SDK to
activate network alarm. Comparing with the local alarm, there is no type, anti-dither, alarm upload
function.
Please highlight icon to select the corresponding function. After setting all the setups please
click save button.
To Next Page
Loading...
Need help?
General