switch the camera from no-WDR mode to the WDR mode,
system may lose several seconds record video.
HLC: After you enabled HLC function, the device can lower
the brightness of the brightest section according to the HLC
control level. It can reduce the area of the halo and lower the
brightness of the whole video.
OFF: It is to disable the BLC function. Please note this
function is disabled by default.
It is to set the white balance mode. It has effect on the general
hue of the video. This function is on by default. You can select
the different scene mode such as auto, sunny, cloudy, home,
office, night, disable and etc to adjust the video to the best
quality.
Auto: The auto white balance is on. System can auto
compensate the color temperature to make sure the vide
color is proper.
Sunny: The threshold of the white balance is in the sunny
mode.
Night: The threshold of the white balance is in the night
mode.
Customized: You can set the gain of the red/blue channel.
The value reneges from 0 to 100.
It is to set device color and the B/W mode switch. The default
setup is auto.
Color: Device outputs the color video.
Auto: Device auto select to output the color or the B/W video
according to the device feature (The general bright of the
video or there is IR light or not.)
B/W: The device outputs the black and white video.
Sensor: It is to set when there is peripheral connected IR
light.
5.5.1.3 Encode
It includes encode setup, snapshot setup, video overlay and storage path setup.
5.5.1.3.1 Encode
From main window->Setup->Camera->Encode->Encode, the encode interface is shown as below. See
Figure 5-23.
To Next Page
Loading...
