Time length: It is to pack according to time. The value ranges from 1 to 60 minutes. Default value is
60 minutes.
File length: It is to pack according to file length. The default setup is 1024M. The value ranges from
128M to 2048M.
Instant playback: It is to set playback time you can view in the preview interface. The value ranges
from 5 to 60 minutes.
Auto logout: Here is for you to set auto logout interval once login user remains inactive for a
specified time. Value ranges from 0 to 60 minutes.
IPC Time Sync: You can input an interval here to synchronize the DVR time and IPC time.
Navigation bar: Check the box here, system displays the navigation bar on the interface.
Startup wizard: Once you check the box here, system will go to the startup wizard directly when the
system restarts the next time. Otherwise, it will go to the login interface.
Mouse sensitivity: You can set double click speed via dragging the slide bard. You can Click Default
button to restore default setup.
Figure 4-7
4.2.1.2 Date and Time
The interface is shown as in Figure 4-8.
Date format: There are three types: YYYYY-MM-DD: MM-DD-YYYYY or DD-MM-YYYY.
Date separator: There are three denotations to separate date: dot, beeline and solidus.
DST: Here you can set DST time and date. Here you can set start time and end time by setting
corresponding week setup or by setting corresponding date setup.
NTP: It is to set NTP server information. Check the NTP box to enable this function.
Host IP: Input the server IP that installed the NTP server.
Manual update: Click it, you can sync DVR time with the NTP server manually.
Port: System supports TCP transmission only. The port value is 123.
To Next Page
Loading...
Need help?
General