Figure 5-6 Search device
●
To view the live image of a camera, click LIVE and then enter the username and
password. You can only view live images of cameras accessed through private
protocol.
●
To lter the remote devices, select device name from the Filter drop-down list.
●
To lter out the uninitialized devices, click the Not Initialized tab, and then you
can initialize the devices remotely.
●
To view all remote devices added through plug and play, click the Not Auto
Connected tab. You can remove devices added through plug and play, and they
can be automatically added again after plug and play is enabled.
2. (Optional) Enable Plug and Play.
When Plug and Play is enabled, the Device automatically adds cameras on the same
LAN.
For uninitialized cameras, the Device automatically initializes them before adding
them.
3. Enable H.265 Auto Switch
When H.265 Auto Switch is enabled, the video compression standard of added
remote devices is switched to H.265 automatically.
4. Double-click a camera, or select a camera and then click Add to register it to the
Added Device list.
5. Click Next.
Step 5 Manage HDD. You can view HDD name, physical position, health status, capacity, and
more.
User's Manual
117
To Next Page
Loading...
Need help?
General
