Dahua NVR2104-I2 User Manual

Parameter Description
●
After binding NIC cards, you need to restart the Device to make the
change eective.
IP Version Select IPv4 or IPv6. Both versions are supported for access.
MAC Address Displays the MAC address of the Device.
DHCP
Enable the system to allocate a dynamic IP address to the Device. There is
no need to set IP address manually.
●
If you want to manually congure the IP information, disable the DHCP
function rst.
●
If PPPoE connection is successful, the IP address, subnet mask, default
gateway, and DHCP are not available for conguration.
IP Address
Enter the IP address and congure the corresponding subnet mask and
default gateway.
●
The IP address and default gateway must be on the same network
segment.
●
Click Test to check whether the IP address is available.
Subnet Mask
Default Gateway
MTU Displays the MTU value of the NIC card.
Step 3 On the TCP/IP page, congure the DNS server.
This step is compulsive if you want to use the domain service.
●
Obtain DNS server automatically.
When there is DHCP server on the network, you can enable DHCP so that the Device
can automatically obtain a dynamic IP address.
●
Congure DNS server manually.
Select the IP version, and then enter the IP addresses of preferred and alternate DNS
server.
Step 4 Select a NIC card as the default card.
Step 5 Click Apply.
5.11.2 Routing Table
Background Information
You can congure the routing table so that the system can automatically calculate the best path for
data transmission.
Procedure
Step 1 Select Main Menu > NETWORK > TCP/IP > Routing Table.
User's Manual
315

Dahua NVR2104-I2 Specifications

General

Brand	Dahua
Model	NVR2104-I2
Category	Network Hardware
Language	English