Step 2 Click to enable the function.
Step 3 Conîš‚gure the email parameters.
Table 5-63 Email parameters
Parameter Description
SMTP Server Enter the address of SMTP server of sender’s email account.
Port Enter the port of SMTP server. The default value is 25.
Username
Enter the username and password of sender’s email account.
Password
Anonymous Enable anonymous login.
Receiver
Select the receiver to receive the notiîš‚cation. You can select up to three
receivers.
Email Address Enter the email address of mail receivers.
Sender
Enter the sender’s email address. You can enter up to three senders
separated by comma.
Subject
Enter the email subject.
You can enter Chinese, English and numerals with the length limited to
64 characters.
Attachment
Enable the attachment function. When there is an alarm event, the
system can attach snapshots as an attachment to the email.
Encryption Type
Select the encryption type from NONE , SSL, or TLS.
For SMTP server, the default encryption type is TLS.
Interval (Sec.)
Set the interval at which the system sends an email for the same type of
alarm event to avoid excessive pileup of emails caused by frequent alarm
events.
The value ranges from 0 to 3600. 0 means that there is no interval.
Health Mail
Enable the health test function. The system can send a test email to
check the connection.
Sending Interval
Set the interval at which the system sends a health test email.
The value ranges from 30 to 1440. 0 means that there is no interval.
Test
Click Test to test the email sending function. If the conîš‚guration is
correct, the receiver’s email account will receive the email.
Before testing, click Apply to save the settings.
Step 4 Click Apply.
User's Manual
332
To Next Page
Loading...
Need help?
General
