●
When connecting to a third-party IPC, make sure that the IPC supports ONVIF protocol and
DHCP is enabled.
Procedure
Step 1 Select Main Menu > NETWORK > Switch.
Figure 5-219 Switch
Step 2 Congure IP address, subnet mask, and default gateway..
Do not set the IP address to the same network segment with the NVR. We recommend
you use the default setting.
Step 3 Click Apply.
Related Operations
When connecting IP camera to PoE port, if all the channels are occupied, the system prompts you
whether to take place of one channel.
Table 5-68 PoE operation
PoE operation Description
Connect to PoE port
When an IPC is connected to the PoE port, the system automatically
assigns the IP address to the IPC according to the set IP segment. The
NVR will try the method of arp ping to assign the IP address. If DHCP is
enabled on the NVR, the NVR will use DHCP to assign the IP address.
●
When IP address is successfully set, the system will broadcast through
the switch function. If there is a response from the IPC, it means the
connection is successful, and the NVR will log in to the IPC. You can
nd the corresponding channel occupied and there is a PoE icon at
the upper-left corner.
User's Manual
338
To Next Page
Loading...
Need help?
General
