Questions Reasons
Reboot the device to restore the default password.
After I login the Web, I cannot
nd the remote page to add the
IPC.
Clear the Web controls and load again.
There is IP and gateway, I can
access the internet via the
router. But I cannot access the
internet after I reboot the NVR.
Use command PING to check you can connect to the gateway or
not. Use telnet to access and then use command "ifcong –a" to
check device IP address. If you see the subnet mask and the
gateway has changed after the reboot. Upgrade the
applications and set again.
I use the VGA monitor. I want to
know if I use the multiple-
window mode, I see the video
from the main stream or the sub
stream?
●
For 32-channel series product, the 9/16-window is using the
sub stream.
●
For 4/8/16 series product, system is using the main stream
no matter you are in what display mode.
Daily Maintenance
●
Use the brush to clean the board, socket connector and the chassis regularly.
●
The device shall be soundly earthed in case there is audio/video disturbance. Keep the device
away from the static voltage or induced voltage.
●
Unplug the power cable before you remove the audio/video signal cable, RS-232 or RS-485
cable.
●
Do not connect the TV to the local video output port (VOUT). It might result in video output
circuit.
●
Always shut down the device properly. Use the shutdown function in the menu, or you can
press the power button in the rear pane for at least three seconds to shut down the device.
Otherwise it might result in HDD malfunction.
●
Make sure the device is away from the direct sunlight or other heating sources. Keep the sound
ventilation.
●
Check and maintain the device regularly.
User's Manual
433
To Next Page
Loading...
Need help?
General
