Daikin D-BACS - Page 372

2.7 <KRP1B61 / KRP1B56, 59 / KRP1C3> Adaptor for Wiring 355
Adaptor
KRP1B56, 59
z Installation differs according to models as shown below.
Do not bundle low and high voltage wires together.
z Bundle any axcess wires with the attached be wraps so as to keep loose wirings off the indoor unit PC board.
Ceiling-mounted cassette type
Accessories
NOTE
Check if the following accessories are included in the kit.
PC board support
Clamp
Installation manual
× 4
× 3
× 1
Adaptor
× 1
•
Kits vary according to applicable models.
•
A special adaptor fixing plate and box are required for the following models.
...........................................................
....................................................................
.........................................................................
.....................................................
................................................................................
.........................................................
FHYCP–D, FXF(Q)
FH(Y)C(P)–B
FH(Y)C–K
FH(Y)(P), FHQ, FXHQ
FV(Y)
FFQ, FXZQ, FXD(Q)
KRP1D98 · KRP1DA98
KRP1C98 · KRP1CA98
KRP1B98
KRP1C93 · KRP1CA93
KRP4A95
KRP1B101 · KRP1BA101
Ceiling-mounted Duct type
NOTE: Installation box for adaptor PC board is required to install
the adaptor.
Adaptor
Lid of installation box
KRP1D98 (Optional accessory)
KRP1DA98
NOTE: Installation box for adaptor PC board is
required to install the adaptor.
PC board support
Ceiling-mounted cassette type
KRP1B59
KRP1BA59
FXF(Q)
(Multiflow type)
Installation box for
adaptor PC board
KRP1D98
(Optional accessory)
KRP1DA98
FXZQ
(600×600 Multiflow type)
FXD(Q)
(Ceiling-mounted Duct type)
Adaptor
FFQ,FXZQ....KRP1B57
KRP1BA57
FXD(Q).........KRP1B56
PC board support
Lid of installation box
KRP1B101 · KRP1BA101
(Optional accessory)
KRP1B101 · KRP1BA101
(Optional accessory)
Installation box
for adaptor PC board