Danfoss VACON NXP IP00 - Page 4

5.3
5.4
5.5
5.5.1
5.5.1.1
5.5.1.2
5.5.1.3
5.5.2
5.5.2.1
5.5.2.2
5.5.2.3
6
6.1
6.1.1
6.1.2
6.1.3
6.1.4
6.1.5
6.1.6
6.2
6.3
6.4
6.5
6.6
6.7
6.7.1
6.7.2
6.7.3
6.7.4
6.7.5
6.7.6
7
7.1
7.2
7.3
7.3.1
7.3.2
Cabinet Requirements for FR8–FR12 32
Cabinet Requirements for FR13–FR14 32
Installation Sequence 38
Installation Sequence for FR8–FR12 38
Mounting the AC Choke, FR10–FR12 38
Mounting the Power Unit, FR8–FR12 39
Mounting the Control Unit, FR8–FR12 39
Installation Sequence for FR13–FR14 40
Mounting the AC Chokes, FR13–FR14 40
Mounting the Power Unit, FR13–FR14 41
Mounting the Control Unit, FR13–FR14 42
Electrical Installation 44
Cable Connections 44
General Cable Requirements 44
UL Standards on Cabling 45
Cable Selection and Dimensioning 45
Fuse Selection 45
Principle of the Power Unit Topology 45
DC Supply and Brake Resistor Cables 46
EMC-compliant Installation 47
Grounding 47
AC Choke Connections 49
Common-mode Chokes on Motor Cables 50
Fuse Installation 50
Installing the Cables 51
Additional Instructions for Cable Installation 51
Installing the Cables, FR8 52
Installing the Cables, FR9 55
Installing the Cables, FR10/FR12 57
Installing the Cables, FR11 60
Installing the Cables, FR13/FR14 63
Control Unit 69
Control Unit Components 69
Control Voltage (+24 V/EXT +24 V) 69
Control Unit Cabling 70
Selection of the Control Cables 70
Control Terminals on OPTA1 70
AQ351737303996en-000201/DPD008884 | Danfoss A/S © 2023.09
Contents
VACON® NXP IP00 Drive Modules
Operating Guide