Danfoss VACON NXP IP00 - Page 5

7.3.2.1
7.3.2.2
7.3.3
7.4
7.4.1
7.4.2
7.5
7.6
8
8.1
8.2
8.2.1
8.3
8.3.1
8.3.2
8.3.3
8.4
8.4.1
8.4.2
8.4.3
8.4.4
8.4.4.1
8.4.5
8.4.6
8.4.7
8.4.7.1
8.4.7.2
8.5
8.5.1
8.5.2
8.5.3
8.6
8.6.1
8.6.2
8.7
8.7.1
8.7.2
Digital Input Signal Inversions 72
Jumper Selections on the OPTA1 Basic Board 73
Control Terminals on OPTA2 and OPTA3 74
Fiber Cable Connections 75
Connecting the Optic Fiber Cables, FR10–FR12 78
Connecting the Optic Fiber Cables, FR13–FR14 80
Installation of Option Boards 83
Galvanic Isolation Barriers 83
Using the Control Panel 84
Navigating on the Control Panel 84
Using the Monitoring Menu (M1) 84
Monitored Values 84
Using the Parameter Menu (M2) 86
Finding the Parameter 86
Selecting Values 87
Editing the Values Digit by Digit 87
Using the Keypad Control Menu 89
Finding the Keypad Control Menu 89
Keypad Control Parameters M3 89
Changing the Control Mode 90
Keypad Reference 90
Editing the Frequency Reference 90
Changing the Rotation Direction 90
Disabling the Stop Motor Function 91
Special Functions in Keypad Control Menu 91
Selecting the Keypad as the Control Mode 91
Copying the Frequency Reference Set to the Control Panel 91
Using the Active Faults Menu (M4) 92
Finding the Active Faults Menu 92
Examining the Fault Time Data Record 92
Fault Time Data Record 92
Using the Fault History Menu (M5) 93
Fault History Menu (M5) 93
Resetting the Fault History 93
Using the System Menu (M6) 94
Finding the System Menu 94
System Menu Functions 94
AQ351737303996en-000201/DPD00888 | 5Danfoss A/S © 2023.09
Contents
VACON® NXP IP00 Drive Modules
Operating Guide