Enter/Exit Programming Mode
Product Reference Guide
127
Datalogic 2 of 5 Set Length 1
This setting has no effect for AR models.
This feature specifies one of the bar code lengths for Datalogic 2 of 5
Length Control. Length 1 is the minimum label length if in Variable Length
Mode, or the first fixed length if in Fixed Length Mode. The length includes
the bar code’s data ch
aracters only.
The length can be set from 2 to 50 characters in increments of two. See "Set Length 1" on
page 239 for more detailed programming instructions.
$CD2L1
Select Datalogic 2 of 5 L
ength 1 Setting
To configure this feature, scan the ENTER/EXIT bar
code above, th
en the bar code at left followed by dig-
its from the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
an
d not save the entry string. You can then start
again at the beginning.
~
CANCEL
06 = Length 1 is 6 Characters
To Next Page
Loading...
