Datalogic PD9330 - Double Read Timeout

To Next Page

To Previous Page

Enter/Exit Programming Mode

PowerScan™ PD9330/PBT9300/PM9300

Double Read Timeout

Double Read Timeout prevents a double read of the same label by setting

the minimum time allowed between reads of labels of the same symbology

and data. If the unit reads a label and sees the same label again within the

specified timeout, the second read is ignored. Double Read Timeout does

not apply to scan modes that require a trigger pull for each label read.

$CSNDR0A(CR)

Double Read Timeout = 0.1 Second

$CSNDR14(CR)

Double Read Timeout = 0.2 Second

$CSNDR1E(CR)

Double Read Timeout = 0.3 Second

$CSNDR28(CR)

Double Read Timeout = 0.4 Second

$CSNDR32(CR)

Double Read Timeout = 0.5 Second

$CSNDR3C(CR)

Double Read Timeout = 0.6 Second

DEFAULT

$CSNDR46(CR)

Double Read Timeout = 0.7 Second

Other manuals for Datalogic PD9330