To Next Page

To Previous Page

Enter/Exit Programming Mode

206

PowerScan™ PD9330/PBT9300/PM9300

DIRECT RADIO AUTOLINK

This feature enables/disables the ability to link a wireless handheld to a

base station without scanning the Unlink label first.

DEFAULT

$CBTDL00(CR)

Direct Radio Link = Unlink Label Required

$CBTDL01(CR)

Direct Radio Link = Automatic Unlinking

RF ADDRESS STAMPING

These features allow configuration of source radio data inclusion.

Source Radio Address Transmission

Enables/disables the ability of source radio address information to be trans-

mitted to the host and, if so, at what po

sition with respect to the label data.

See page 279 in “References” for detailed information and examples for set-

ting this feature.

DEFAULT

$CBTAS00(CR)

Source Radio Address Transmission = Do Not Include

$CBTAS01(CR)

Source Radio Address Transmission = Prefix

When included as a prefix, the source-radio ID is displayed after all

label formatting has been applied. The 6 byte hex address is sent as

12 ascii characters, i.e., an address of 00 06 66 00 1A ED will be sent as

(shown in hex): 30 30 30 36 36 36 30 30 31 41 45 44

Datalogic PD9330 User Manual

Other manuals for Datalogic PD9330