Datalogic PD9330 - Date-Time Separator

Enter/Exit Programming Mode
210 PowerScan™ PD9330/PBT9300/PM9300
Date-Time Separator
Sets the character used to separate Date and Time from the next field in
message.
DEFAULT
$CRFTD0000\r
Disable Date-Time Separator
$CRFTD01\r
Set Character Separator =
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
le
ft followed by 2 digits from the Alphanumeric charac-
ters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
bar code twi
ce.
Make a mistake? Scan the CANCEL bar code to abort
and no
t save the entry string. You can then start again
at the beginning.
~
CANCEL