Enter/Exit Programming Mode
240
PowerScan™ PD9330/PBT9300/PM9300
Set String Terminator
Sets the terminator of the predefined strings.
Set String Terminator
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
le
ft followed by 32 digits from the Alphanumeric charac-
ters in
Appendix D, Keypad.
The digits must be the hexadecimal ASCII representation
of the de
sired characters. If less than the expected
string of 16 characters are selected, scan the ENTER/
EXIT bar code to terminate the string.
If the first 2 digits are 0, the feature is disabled. End by
scanning t
he ENTER/EXIT bar code twice.
Make a mistake? Scan the CANCEL bar code to abort and
not save the ent
ry string. You can then start again at the
beginning.
CANCEL
To Next Page
Loading...
Need help?
General
