Enter/Exit Programming Mode
Product Reference Guide
29
RS-232/USB-COM INTERFACES
INTERCHARACTER DELAY on page 30
BEEP ON ASCII BEL on page 30
BEEP ON NOT ON FILE on page 31
ACK NAK OPTIONS on page 31
ACK CHARACTER on page 32
NAK CHARACTER on page 32
ACK NAK TIMEOUT VALUE on page 33
ACK NAK RETRY COUNT on page 33
ACK NAK ERROR HANDLING on page 34
INDICATE TRANSMISSION FAILURE on page
34
DISABLE CHARACTER on page 35
ENABLE CHARACTER on page 35
The programming bar codes in this chapter allow modifications to the stan-
dard RS-232 and USB-Com in
terfaces. Reference Appendix C, Standard
Defaults for a listing of standard factory settings.
To Next Page
Loading...
Need help?
General
